30-80Khz 100KW High Frequency Induction Heating Machine for Pipe, Shaft, Gear Hardening
Parameter
| Type |
HF-100KW |
| Work power |
380V/ 415V/ 440V /480V *3Phase 50-60HZ |
| Work Voltage |
340V-480V AC |
| Output power |
100KW |
| Input current |
150A |
| Working Frequency |
30-80KHZ |
| The flow rate of cooling water |
0.12-0.3Mpa 14L/Min |
| Water temperature protection point |
40℃ |
| Duty cycle |
100% (40degree room temperature) |
| Weight |
Main parts:135KGS
Transformer Parts: 98KGS
|
| Size |
Main Part: 830*500x1100 mm
Transformer :640x360x590 mm
|
Features:
1. Non-contact Heating is the biggest Characteristic of the induction heating.
2. High Frequency, Heating is fast, good for quenching all kinds of shaft, pipe, gear, lead Guide, Sprock and so on.
3. Infineon module and Inverting technologies of third generation been used; Higher reliability and lower maintenance cost.
4. 100% Duty cycle, continuous working is allowed at maximum power output.
5. Simple to install, Installation can be done by unprofessional person very easily;
6. Double digital Screen display, better to know the working performance of the machine!
7. Energy Saving Up to 20-30% compare with SCR machine.
8. Diode Rectification Technology Make sure high power factory—0.98.
9. Soft Switch Technology And prefect Protection system( Over Heat, Over Current, Under Voltage, Over Voltage, Phase Fail, Lack Water) enhance Good Reliability.
Application:
Heat Treatment (surface quench):
It is mainly aims to change the rigidity of the metal materials through the heat treatment to work pieces. Detail applications are stated as follows:
1. Quench for various hardware and tools, such as plier, wrench, hammer, ax, screwing tools and shear (orchard shear).
2. Quench for various automobile and motorcycle fittings, such as crankshaft, connecting rod, piston pin, chain wheel, aluminum wheel, valve, rock arm shaft, semi drive shaft, small shaft and fork.
3. Various electric tools, such as gear and axes.
4. Quench for machine tools, such as lathe deck and guide rail.
5. Quench for various hardware metal parts and machined parts, such as shaft, gear (chain wheel), cam, chuck and clamp etc.
6. Quench for hardware molds, such as small-size mold, mold accessory and inner hole of mold.
Advantage
1. Using the third generation Infineon IGBT.
2. DELIXI Air Switch
3. All screws in our machine are stainless steel.
4. Phase Bridge (Germany IXYS)
5. Water Temperature and water Pressure meter in the machine,double protection for the machine.
Your message must be between 20-3,000 characters!
